Understanding the maximum capacity value
The maximum capacity is recorded or displayed at various levels.
Measurement point
Field
Description
MaximumCapacity
Manual measurement point capacity to overwrite the capacity of the referenced location
LocationCapacity
(Read only) end result. Default capacity of referenced location or overwritten by the MaximumCapacity field.
Measurement point reading
Field
Description
NrOfPeopleCapacity
Measurement point LocationCapacity value.
Measurement point summarized reading
Field
Description
TotalMaximumPersonCountOT
Measurement point reading LocationCapacity value multiplied by the value of the field NrOfOccupiedOT (cumulative value for calculation)
Capacity
Measurement point reading LocationCapacity value.
Because of this fact, a specific logic is used to determine which value is to be displayed in the application.
1. The Measurement point > MaximumCapacity field is leading. If this field contains a value, it will be used always. The end result is displayed in the (read only) LocationCapacity field.
2. The Measurement point reading > NrOfPeopleCapacity field is filled by the Planon application - it is not a measured value. To determine the value, the following logic is followed:
Schematic overview that helps to understand which capacity value is taken based on the answer to a few questions.Schematic overview that helps to understand which capacity value is taken based on the answer to a few questions.
3. The measurement point summarized reading values reflect the calculations performed in summarization (hourly/daily/monthly). For an example, see Summarization - calculations.